Contact us
- : 0086-371-86151627 0086-371-86151827
- : 0086-371-86011881
- : [email protected]
- : [email protected]
- : bebonchina
Products- Boiler steels
- High carbon steel
- High Yield steel
- steel for welded tubes
- General construction steel
- steel with Cr.,Mo.,Cr-Mo
- Steel for large diameter pipes
- Simple pressure vessels steel
- Steel for gas cylinders and gas vessels
- General purpose structural steels
- Steel for boilers and pressure vessels
- steel resistant to atmospherical corrosion
- Carbon steel and low alloy steel
- Fine-grain structural steels,normalised rolled
- weldable normalized fine grained pressure vessel steels
Tensile yield strength and heat treatment of SA516 Gr415 vessel plate
SA516 Gr415 plate is an American standard pressure vessel steel plate, material name: carbon steel plate for medium and low temperature pressure vessels.
Trademark: SA516 Gr60N, SA516 Gr70N, A516 GR60 A516 GR70 for HIC+SSC test.
Execution specification: ASTM/ASME specification, this specification is mainly used to improve the notch resistance of steel plates for welded pressure vessels.
Tensile strength of SA516 Gr415 vessel plate:
SA516 material is divided into the following strength grades:
| Grade U.S(SI) | Tensile Strength ksi(MPa) |
| 55 (380) | 55-75 (380-515) |
| 60 (415) | 60-80 (415-550) |
| 65 (450) | 65-85 (450-585) |
| 70 (485) | 70-90 (485-620) |
Heat treatment of SA516 Gr415 vessel plate: SA516Gr60 steel plate thickness ≤ 1.5in (40mm) is usually supplied in rolled condition, steel plate can also be normalized or stress relieved, or normalized and tempered. SA516Gr60 vessel plate thickness > 1.5in.( 40mm) should be normalized. If agreed by the purchaser, SA516 Gr55, SA516 Gr60, SA516 Gr70 allow to use a cooling rate greater than that in air to improve resistance, but the steel plate only needs to be subsequently tempered in the range of 1100-1300 degrees F (595-705).